收藏本站
NXP Semiconductors
PCA9685
16-channel, 12-bit PWM Fm+ I 2 C-bus LED controller
7.3.2 Mode register 2, MODE2
Table 5. MODE2 - Mode register 2 (address 01h) bit description
Legend: * default value.
Bit
7 to 5
4
Symbol
-
INVRT [1]
Access
read only
R/W
Value
000*
0*
Description
reserved
Output logic state not inverted. Value to use when external driver used.
Applicable when OE = 0.
1
Output logic state inverted. Value to use when no external driver used.
Applicable when OE = 0.
3
OCH
R/W
0*
Outputs change on STOP command [2] .
1
Outputs change on ACK [3] .
2
OUTDRV [1]
R/W
0
The 16 LEDn outputs are configured with an open-drain structure.
1*
The 16 LEDn outputs are configured with a totem pole structure.
1 to 0
OUTNE[1:0] [4]
R/W
00*
When OE = 1 (output drivers not enabled), LEDn = 0.
01
1X
When OE = 1 (output drivers not enabled):
LEDn = 1 when OUTDRV = 1
LEDn = high-impedance when OUTDRV = 0 (same as OUTNE[1:0] = 10)
When OE = 1 (output drivers not enabled), LEDn = high-impedance.
[1]
[2]
[3]
[4]
See Section 7.7 “ Using    the PCA9685 with and without external drivers    ” for more details. Normal LEDs can be driven directly in either
mode. Some newer LEDs include integrated Zener diodes to limit voltage transients, reduce EMI, protect the LEDs and these must be
driven only in the open-drain mode to prevent overheating the IC.
Change of the outputs at the STOP command allows synchronizing outputs of more than one PCA9685. Applicable to registers from
06h (LED0_ON_L) to 45h (LED15_OFF_H) only. 1 or more registers can be written, in any order, before STOP.
Update on ACK requires all 4 PWM channel registers to be loaded before outputs will change on the last ACK.
See Section 7.4 “ Active    LOW output enable input   ” for more details.
7.3.3 LED output and PWM control
The turn-on time of each LED driver output and the duty cycle of PWM can be controlled
independently using the LEDn_ON and LEDn_OFF registers.
There will be two 12-bit registers per LED output. These registers will be programmed by
the user. Both registers will hold a value from 0 to 4095. One 12-bit register will hold a
value for the ON time and the other 12-bit register will hold the value for the OFF time. The
ON and OFF times are compared with the value of a 12-bit counter that will be running
continuously from 0000h to 0FFFh (0 to 4095 decimal).
Update on ACK requires all 4 PWM channel registers to be loaded before outputs will
change on the last ACK.
The ON time, which is programmable, will be the time the LED output will be asserted and
the OFF time, which is also programmable, will be the time when the LED output will be
negated. In this way, the phase shift becomes completely programmable. The resolution
for the phase shift is 1 ? 4096 of the target frequency. Table 6 lists these registers.
The following two examples illustrate how to calculate values to be loaded into these
registers.
PCA9685
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 3 — 2 September 2010
? NXP B.V. 2010. All rights reserved.
15 of 51
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
PCA9922PW,118 IC LED DRIVER LINEAR 16-TSSOP
PCA9955TW,118 IC LED DRVR CONST CURR
PCF85102C-2P/03,11 IC EEPROM 2KBIT 100KHZ 8DIP
PCF85103C-2T/00,11 IC EEPROM 2KBIT 100KHZ 8SOIC
PCF8570T/F5,512 IC SRAM 2KBIT 100KHZ 8SOIC
PCF8582C-2T/03,118 IC EEPROM 2KBIT 100KHZ 8SOIC
PCF8594C-2T/02,118 IC EEPROM 4KBIT 100KHZ 8SOIC
PCF8598C-2P/02,112 IC EEPROM 8KBIT 100KHZ 8DIP
相关代理商/技术参数
PCA9685PW/Q900,118 功能描述:LED显示驱动器 LED Driver 2.3V-5.5V 6mA RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube
PCA9691BS/1 制造商:NXP Semiconductors 功能描述:IC ADC/DAC 8-BIT I2C 16-HVQFN 制造商:NXP Semiconductors 功能描述:IC, ADC/DAC, 8-BIT, I2C, 16-HVQFN
PCA9691BS/1,118 功能描述:I2C 接口集成电路 ADC/DAC 16-Pin HVQFN EP RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16
PCA9691BS/1118 制造商:NXP Semiconductors 功能描述:PCA9691BS/HVQFN16/REEL13//1
PCA9691T/1，112 制造商:NXP Semiconductors 功能描述:
PCA9691T/1，118 制造商:NXP Semiconductors 功能描述:
PCA9691T/1,512 功能描述:I2C 接口集成电路 8b A/D AND D/A COVERTER RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16
PCA9691T/1,518 功能描述:模数转换器 - ADC 8-bit A/D and D/A converter RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32